Wireless interactive HH9000 Series Manual de usuario descargar pdf (Pagina 11)

Write down the IP Address, Subnet Mask, Default Gateway, then setup the IP Camera address

according to your computer’s IP address. For example: 192.168.1.100. Make sure the Default

Gateway and Subnet Mask are the same.

Click 【Set Parameters】as follows

Modify any relative parameters; click “OK”, and then the IP camera will restart.

3.2 Check Connection

To test the IP camera connection: “Start”→ “Run”→ “command”, get following interface, input:

ping 192.168.1.100. Click “Enter” button.

If your packets are received, it means the IP Camera is working normally and is connected to network

accordingly. If you do not get a reply then confirm the IP address settings on your computer as well

as network cables. Then use the Search NVS software to search and modify network parameters

(such as IP address, subnet mask, gateway and so on).

11/ 30

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 29 30

Sin comentarios

Wireless interactive HH9000 Series Manual de usuario Pagina 11